Free · runs in your browser

Surround sound test

Check every speaker in a 5.1 or 7.1 system. We detect how many channels your browser can drive, then you press each speaker and confirm where the beeps came from.

  • 5.1 and 7.1
  • Detects your channel count
  • Test files as a fallback

1 · Detect your channels

2 · Press each speaker

Starts at 20% volume. Turn your device volume down before the first press.

Confirming
Surround test

To: Your speaker system · via your browser

Date—
Device ch.—
Layout2.0
Rate—
FrontNot tested
SurroundNot tested
SubwooferNot tested
audiotesthq.com

Your result appears here as you answer. Nothing is uploaded.

More tests: follow the sign

A surround sound test plays a sound on one speaker at a time so you can confirm each one is connected, working and in the right place. Press Detect my output: if your browser reports 6 or more channels, press each speaker on the plan and confirm the beeps came from it. If it reports only 2, play our 5.1 and 7.1 test files on the device instead.

Why does it say 2 channels?

A browser can only use the channels your operating system gives it. Laptops, TVs connected over HDMI in stereo mode, soundbars and Bluetooth devices usually report 2 channels, even when the speakers behind them are 5.1. In that case the test cannot reach individual surround speakers from the browser, and the honest answer is to play a multichannel file directly. Our files are built to Microsoft's multichannel WAV channel order.

Channel order

Channel5.17.1
1Front leftFront left
2Front rightFront right
3CentreCentre
4Subwoofer (LFE)Subwoofer (LFE)
5Surround leftRear left
6Surround rightRear right
7–Side left
8–Side right

Source: Microsoft, WAVEFORMATEXTENSIBLE channel mask (channels are stored in speaker-bit order: front left, front right, front centre, low frequency, back left, back right, side left, side right). The test plays a 50 Hz tone on the subwoofer channel and 1 kHz beeps on the others.

Where should the speakers go?

The international reference layout for 5.1, ITU-R BS.775, places the front left and right speakers 30° either side of the centre line, the centre speaker straight ahead, and the two surround speakers between 100° and 120° from the front, all at about ear height. Real rooms rarely allow the exact angles; get as close as you can and use your receiver's distance and level settings for the rest. For 7.1, follow your receiver's manual.

A speaker played from the wrong place?

  1. Check which receiver terminal each speaker wire goes to.
  2. In the receiver's speaker setup, check the layout (5.1 or 7.1) and that no speaker is set to None.
  3. On Windows, open Control Panel › Sound, select your output, choose Configure and pick the matching layout.

Common questions

How do I test my 5.1 surround sound?

Press Detect my output on this page. If it finds 6 channels, press each speaker and confirm. If it finds 2, download our 5.1 test file and play it on the device connected to your speakers.

Why are my rear speakers silent?

Usually the source is stereo, the receiver is set to a stereo mode, or the speakers are set to None in the receiver's setup. Play a 5.1 test file to rule out the source.

Can a browser play 7.1 audio?

Only if your operating system exposes 8 output channels to the browser. Many setups do not; the test tells you what yours reports.

What is the .1 in 5.1?

The low frequency effects (LFE) channel, which carries deep bass for a subwoofer.

Last reviewed 14 November 2026 by Sri Murugan Systems. Found a mistake? Tell us.